Robomow RL2000 - User Manual

84 pages

Save Page as PDF

To Next Page

Operating & Safety Manual

RL MODELS

WWW.ROBOMOW.COM / WWW.ROBOMOW.EU

DOC0100F

Main Page

Questions and Answers

M
Michelle MorenoSep 12, 2025
Why does my Robomow RL2000 Lawn Mower leave large patches of uncut grass?
- C
  Christine CaldwellSep 12, 2025
  If your Robomow lawn mower leaves large patches of uncut grass, it could be due to several reasons. The power pack may not be fully charged; connect the charger until the 'Ready–Keep Charging' message appears. The 'Work Time' might be insufficient for the zone size; increase it under 'User Preferences' or set it to 'MAX'. Also, the power pack might be nearing its end of life or damaged from poor maintenance, requiring replacement. Finally, the grass may be overgrown or wet; raise the cutting height and avoid cutting wet grass.
J
jamie09Sep 15, 2025
Why doesn't the bumper on my Robomow Lawn Mower activate when it hits something?
- D
  dianahansonSep 15, 2025
  The bumper on your Robomow lawn mower may not activate when striking an obstacle if the grass is wet. Operate Robomow when the grass is dry, preferably in the early afternoon. It may also occur if the blades are worn; replace them. The obstacle might be less than 6 inches in height, not rigid enough, or positioned at an angle, preventing square contact with the bumper. Remove the obstacle, set up a wire around it, or exclude it from the cutting area with the perimeter wire.

Summary

Robomow Operating & Safety Manual

Introduction and Safety Information

Covers the welcome, important safety notes, and general warnings.

Warning Decal Definitions

Explains the meaning of various safety symbols and decals on the mower.

Robomow - Safety Features

Details the built-in safety mechanisms of the Robomow mower.

Chapter 1 Planning

Base Station Location and Power Supply

Determining optimal placement for the Base Station and its power supply.

Perimeter Wire Layout Planning

Planning the path of the perimeter wire for lawn boundaries.

Chapter 2 Base Station and Perimeter Wire Setup

Perimeter Wire Setup Procedures

Detailed steps for setting up the perimeter wire, including special cases.

Fastening Perimeter Wire and Completing Setup

Base Station Assembly and Placement

Instructions for assembling and positioning the Base Station.

Testing and Non-Base Zone Setup

Finalizing Setup and Testing

Chapter 3 Preparing Robomow

Initial Setup and Calibration

Procedures for inserting the power pack fuse and calibrating the mower.

Cutting Height and Ground Clearance Adjustment

Chapter 4 The mowing process

Operation Safety and Basic Driving

Safety guidelines and instructions for driving the Robomow manually.

Chapter 5 Setting the Weekly Program (RL2000 only)

Setting Up the Mowing Schedule

Programming the weekly mowing times and days for automatic operation.

Setting Current Time and Canceling Days

Chapter 6 Charging

Charging Methods and Procedures

Chapter 7 Setting Robomow and Advanced Features

Manual User Options and Settings Navigation

Advanced Settings Configuration

Entry Points Setup and Management

Chapter 8 Troubleshooting

Error Messages and Messaging

Interpreting system messages and error codes for fault diagnosis.

Problem Diagnosis by Category

Troubleshooting common issues related to Base Station, Perimeter Switch, and operation.

Chapter 10 Maintenance and Storage

Maintenance Schedule and Procedures

Winter Storage Guidelines

Robomow RL2000 Specifications

General

Type	Robotic lawn mower
Cutting width	530 mm
Cutting system	-
Recommended lawn area	2000 m²
Maximum cutting height	63 mm
Minimum cutting height	26 mm
Grass collecting volume	- L
Power source	Battery
Charging time	20 h
Battery voltage	24 V
Battery capacity	17 Ah
Cordless	Yes