1
Reduction units and gearmotors can be lubricated with grease, oil or for life, depending on their type.
Topping up and/or change must not be performed in case of life-lubed reduction units and gearmotors.
Cycle timings have been defined on the basis of the standard cycle.
The standard cycle is the following: 500 mm high film spool, 1500 mm high pallet, pallet weight equal to 1500
kg, total wrapping cycle consisting of two turns at the base, two turns at the top with rotation speed of 12
r.p.m. or 80 m/1’ and carriage upstroke and downstroke speed equal to 4 m/1’.
To Next Page
Loading...
Need help?
General
