6.7.3. WRAPPING CYCLE WITH FEEDER
To select the cycle.
Turn the jog control to enable the wrapping cycle page.
Press the jog control and select the wrapping with feeder.
Press the jog control to confirm.
The machine performs a cycle aimed at making it easier for the operator to completely cover the pallet and ensuring
the higher possible level of protection. The spool carriage rises until reaching the carriage upper end, moves down
again by approximately 300 mm and stops in this position.
If the machine features a presser, it rises from the load by approximately 200 mm.
At this point, the operator, after placing the covering sheet onto the top of the pallet, activates the cycle again by
pressing the “START” button: the presser moves down again.
The carriage rises until reaching the pallet upper end, performs the programmed upper wrapping turns and moves
down to complete the cycle.
In this way, the position of the covering sheet, tightly bound to upward and downward film turns, is the most suitable
for ensuring an optimum protection of the load against external agents (water, dust, etc.).
(See “Description of user interface”).
To Next Page
Loading...
Need help?
General
