INFORMATION ABOUT THE USE
6.5. MACHINE SWITCHING ON AND OFF
1. Turn the main switch (A) to “I” (ON) to activate the power supply.
The displayed icon indicates that the “Reset” button (B) must be pressed.
For “FREEZER” and “INOX” versions only:
Turning the main switch (A) on automatically activates the electric control panel heating.
The panel heating phase is signalled by the lighting up of the indicator (L).
Once the heating phase, which prevents any actions on controls, is completed, the indicator (L) turns off and
the display indicates that the “Reset” button (B) must be pressed.
Caution - warning
For “FREEZER” and “INOX” versions, it is recommended not to cut off the power supply to the machine.
Caution - warning
For “LP” versions, remove the load after the wrapping cycle.
2. Press the "Reset (B)” button.
3. Set the cycle parameters (See paragraph “cycle parameters setting”).
4. Perform the cycle starting operations (see paragraph “Cycle start and stop”).
5. Turn the main switch (A) to “O” (OFF) to switch the machine off.
6.6. CYCLE PARAMETERS SETTING
6. Switch on the machine (See “Machine switching on and off”).
7. Choose the recipe by turning the jog control.
8. Press the jog control to select the recipe.
9. Turn to view and modify, if necessary, the parameters already set for the recipe.
10. Press the jog control to select the parameter and turn to edit the value.
This value will be stored in the relevant recipe.
To Next Page
Loading...
Need help?
General
