RS-LiDAR-16 User Manual
Figure C - 3: Sensor Stream Data Display in RSView .
C.5 Capture Streaming Sensor Data to PCAP File
1. Click the Record button when streaming (Figure C-4).
Figure C - 4: RSView Record Button.
2. A Choose Output File dialog will pop up. Navigate to where you want the file to be saved and click
the Save button (Figure C-5). RSView begins writing packets to your pcap file. (
Note: RS-LiDAR-16
sensors generate a lot of data. The pcap file can become quite large if the recording duration is lengthy. Also,
it is best to record to a fast, local HDD or SSD, not to a slow subsystem such as a USB storage device or
network drive.
)
Figure C - 5: RSView Record Saving Dialog.
To Next Page
Loading...
