RS-LiDAR-16 User Manual
Appendix F ▪ LiDAR Mechanical Installation Suggestion
Please make sure the platform surface used for mount LiDAR is smooth as possible.
Please make sure the locating pin on the mount surface do exceed 4mm high.
The material of the mount platform is suggested to be aluminum alloy in order to thermolysis.
When the LiDAR is installed, if there is a contact mounting surface on the upper and bottom sides of the
LiDAR, make sure that the spacing between the mounting surfaces is greater than the height of the
LiDAR to avoid squeezing the LiDAR.
We do not suggest to mount the LiDAR in a tilt position that the tilt angle exceed 90 degrees, this will
reduce the sensor life time.
When we route the LiDAR cable in the mount device, we need keep the cable a little slack.
Figure F - 1: LiDAR Mounting Image.
To Next Page
Loading...
