RoboSense RS-LiDAR-16 - Page 61

RS-LiDAR-16 User Manual
61
<param name="model" value="$(arg model)"/>
<param name="device_ip" value="$(arg device_ip)" />
<param name="msop_port" value="$(arg msop_port)" />
<param name="difop_port" value="$(arg difop_port)"/>
<param name="pcap" value="the absolute path to your .pcap file"/>
</node>
<node name="cloud_node" pkg="rslidar_pointcloud" type="cloud_node" output="screen" >
<param name="model" value="$(arg model)"/>
<param name="curves_path" value="$(arg lidar_param_path)/curves.csv" />
<param name="angle_path" value="$(arg lidar_param_path)/angle.csv" />
<param name="channel_path" value="$(arg lidar_param_path)/ChannelNum.csv" />
</node>
<node name="rviz" pkg="rviz" type="rviz" args="-d $(find rslidar_pointcloud)/rviz_cfg/rslidar.rviz" />
</launch>
2. Open a terminal, run node program:
cd ~/atkin_ws
source devel/setup.bash
roslaunch rslidar_pointcloud rs_lidar_16.launch
3. Open a new terminal and run：
rviz