Why does Robuschi Measuring Instruments SENTINEL stop the blower and show '' message?
The Robuschi Measuring Instruments SENTINEL might be stopping the blower and displaying the '' message due to a wrong rotational direction. In this case, check the motor's electrical supply. Another possible cause is a damaged speed transducer. Verify the connection and the continuity of the cables.
What to do if Robuschi Measuring Instruments SENTINEL stops the blower for high temperature?
If the Robuschi Measuring Instruments SENTINEL is constantly stopping the blower because of a high temperature, it could be due to a disconnected temperature transducer. Verify the transducer connection. Alternatively, the temperature transducer might be damaged, in which case you should replace it.
What to do if Robuschi Measuring Instruments SENTINEL stops the blower and shows 'NO OIL' message when there is oil?
If the Robuschi Measuring Instruments SENTINEL stops the blower and displays the message 'NO OIL' even though there is oil, the oil level transducers might be damaged. Check the connection of the oil level transducer with SENTINEL. If the connection is correct, consider changing the transducers.
What to do if Robuschi Measuring Instruments display visualizes P2=atmospheric pressure?
If the Robuschi Measuring Instruments display shows that P2 equals atmospheric pressure, the P2 pressure hose might not be connected or could be cut. Verify the P2 pressure hose connection to SENTINEL and to the blower, and replace it if necessary. Another possibility is that the P2 pressure hose is connected to P1; verify the connection and restore it to the correct configuration.
How to troubleshoot Robuschi Measuring Instruments SENTINEL not switching on?
If the Robuschi Measuring Instruments SENTINEL fails to switch on, first verify the electrical supply from the starting panel. If the power supply is working, replace the SENTINEL fuse.
What to do if Robuschi Measuring Instruments display visualizes P1=-0000mBar?
If the Robuschi Measuring Instruments display shows P1=-0000mBar, the P1 pressure hose might not be connected or could be cut. Verify the P1 pressure hose connection to SENTINEL and to the blower, and replace it if necessary. Another possibility is that the P1 pressure hose is connected to P2; verify the connection and restore it to the correct configuration.
Details the components and functions of the SENTINEL's front panel, including buttons, LEDs, and the display.
Describes the rear panel connections, including pressure hoses, and the function of the SMART-KEY for data storage.
Lists and defines the various parameters monitored by the SENTINEL, such as pressure, temperature, and speed.
Guides through the initial start-up, SMART KEY insertion, and the automatic testing sequence for SENTINEL.
Details the procedure for stopping the blower and the steps required to restart it, including reset options.
Describes how to navigate the menu to select and view specific monitored parameters on the SENTINEL display.
Explains how SENTINEL signals a prealarm condition, including display messages and LED indicators.
Details the alarm condition leading to blower stoppage, display messages, and LED signals.
General| Brand | Robuschi |
|---|---|
| Model | SENTINEL |
| Category | Measuring Instruments |
| Language | English |
To Next Page