22
DGM001519.01 UM Sirius CE/ROTW
^z^dD/E^d>>d/KE
Device installation
Device installation requires that safety precautions are followed, including power requirements and
environmental conditions in the working area.
The installation of the laser device must be performed by qualified technical personnel authorized by the
manufacturer. This person should also carry out tests on the operation of the device after installation in the
designated working area.
Caution: Do not start using the laser device before reading this manual. The warranty does not cover any
damage occurred prior to installation.
Transportation
While transporting the laser, the fittings, fiber, power cord, the pedal and remote locking must be disconnected
from it. Finally, the laser and the accessories should be stored in slots inside the packaging.
Caution: In order to transport the laser device, it must be gripped on both sides using the proper grooves,
by at least two people, and positioned on a trolley.
Packaging
The laser system is normally shipped in a specific cardboard on wood pallet. Upon the container arrival, it will
be a client responsibility to review the packaging, whereas its pre-positioning will be under the responsibility of
the technician responsible for the installation near the working area.
Inspection
It is important that the received material is inspected immediately upon arrival on the following terms:
x Administrative check:
Number of packages
Sizes and weights
x Technical check:
Packaging condition
These checks must be made visually, with the greatest possible care and in the presence of the carrier.
Labelling check
Verifying the integrity and readability of the security labels placed on the device is responsibility of the
user. If labels are damaged, they must be replaced immediately with the labelling shown in the label
plan (Section 2.13).
To Next Page
Loading...