56
ButterCup Installation - Damper Shaft
Remove the damper shaft from the vise and vise blocks.Remove the damper shaft from the vise and vise blocks.
Clamp the lower ButterCup housing into a vise with RockShox Vise Clamp the lower ButterCup housing into a vise with RockShox Vise
Blocks on the wrench flats, damper oriented upward.Blocks on the wrench flats, damper oriented upward.
Tighten the upper ButterCup housing onto the lower housing.Tighten the upper ButterCup housing onto the lower housing.
8
25 mm 8.5 Nm (75 in-lb)
To Next Page
Loading...
