Rockwell Automation 1768-L45 - Page 31

Publication IASIMP-QS003B-EN-P - October 2009 31
Prepare the CompactLogix Hardware Chapter 1
7. Wire the DeviceNet
power supply to the 230V
AC Aux Power Output
connector on the line
interface module.
8. Place the switch in the
position that matches
your supply voltage.
9. Do not turn on incoming
power.
WARNING
Verify that all incoming power is turned off before wiring power.
Input
AC 100-120/200-240V
N L
Isolate power before disconnecting
1606-XL
POWER SUPPLY
DC ok
Output
200W Limited Power
DC 24V / 8A
+ –
DC ok
AC 120V
AC 240V
Line Interface Module
230V AC AUX Power
Top View
L (line)
N (neutral)