74 Publication IASIMP-QS003B-EN-P - October 2009
Chapter 5 Prepare the PanelView Plus Terminal
5. Select Use DHCP [F4] to
select No.
6. Select IP Address [F1].
a. Enter an IP address in
the input panel.
b. Press Enter.
c. Record IP address in
Appendix A.
For information on IP
addresses, see page 89
.
7. Select Subnet Mask [F2].
a. Enter the subnet mask
for your computer,
recorded in Appendix
A.
b. Press Enter.
8. Select OK [F7] to save
settings, then OK [F7]
again to acknowledge
reset message.
To Next Page
Loading...
