Publication IASIMP-QS003B-EN-P - October 2009 81
Prepare the Kinetix 6000 Multi-axis Servo Drive System Chapter 6
6. Use 2.26 Nm (20 lb•in)
torque to tighten the
mounting screws.
7. Remove the protective
boot from the power rail
slot to the right of the
IAM module.
8. Repeat steps 2 through 6
to mount the AM module
in the power rail slot to
the right of the IAM
module.
9. Repeat steps 2 through 6
to mount slot filler
modules in all remaining,
empty power slots.
Mounting Screws on IAM and AM modules.
To Next Page
Loading...
