90 Publication IASIMP-QS003B-EN-P - October 2009
Chapter 7 Configure the EtherNet/IP Network
The Request History
displays all devices in
your network that need
IP addresses.
The Ethernet (MAC)
addresses correspond to
the addresses entered in
Appendix A
.
5. Double-click a request
from one of the devices.
6. Enter the IP address that
you recorded in
Appendix A
and click
OK.
If you are not on an
isolated network, obtain
IP addresses from your
network administrator.
7. Repeat steps 5 - 6 for
each device, except the
PanelView Plus terminal.
If a device is power
cycled, it will not retain its
IP address unless you
disable BOOTP/DHCP.
8. Select the first device in
the Relation List and click
Disable BOOTP/DHCP.
To Next Page
Loading...
