Need help?Do you have a question about the Rockwell Automation CENTERLINE 2100 and is the answer not in the manual?
General| Type | Motor Control Center (MCC) |
|---|---|
| Short Circuit Current Rating (SCCR) | Up to 100kA |
| Voltage Rating | Up to 600V AC |
| Bus Rating | Up to 1200A |
| Current Rating | Up to 1200A |
| Enclosure Type | NEMA 1, NEMA 3R, NEMA 4, NEMA 4X, NEMA 12 |
| Communication Protocols | EtherNet/IP, DeviceNet, ControlNet |
| Standards Compliance | UL 845, IEC 61439 |
| Protection Features | Overload protection, short circuit protection, ground fault protection |
Overview of CENTERLINE Motor Control Centers (MCCs) construction, dimensions, and features.
Details on the information found on MCC section and unit identification labels.
Guidelines for the proper receiving, handling, and storage of MCC units and sections.
Considerations for selecting the optimal location for installing a CENTERLINE MCC.
Instructions and dimensions for securely mounting MCC sections to a foundation.
Information on seismic qualification and anchoring requirements for MCC installations.
Procedures for installing plug-in units into CENTERLINE MCC sections.
Step-by-step guide to safely remove a plug-in unit with a vertical handle.
Details on the requirements for marking equipment with arc flash hazard warnings.
Essential checks and procedures to perform before energizing the MCC.
Guidance on the safe procedure for energizing a newly installed CENTERLINE MCC.
Recommended periodic maintenance tasks for ensuring MCC reliability and safety.
Methods for inspecting units for overheating as part of preventive maintenance.
To Next Page