10 Publication 2100-IN012C-EN-P - April 2009
Preface
The documents in the following table are referenced in this document
and can be obtained from their respective organizations.
Purchased Components and
Additional Instruction
Sheets
When equipment such as transformers, metering, PLCs, or drives are
supplied with the motor control center (MCC), specific manuals and
data sheets are also supplied. These documents should be read and
understood before installing and operating the MCC. Refer to the unit
locations of these devices for their manuals and/or data sheets.
Resource Website
National Electrical Manufacturer’s Association (NEMA)
• NEMA ICS 1-2000 Industrial Control and Systems: General
Requirements
• NEMA ICS 2.3-1995, Instructions for Handling, Operation and
Maintenance of Motor Control Centers Rated Not More Than
600V
www.nema.org
National Fire Protection Association (NFPA)
• NFPA 70 - National Electrical Code
• NFPA 70A - Recommended Practice for Electrical Equipment
Maintenance
• NFPA 70E - Standard for Electrical Safety in the Workplace
www.nfpa.org
Institute of Electrical and Electronic Engineers (IEEE)
IEEE standard C37.20.7 - IEEE Guide for Testing Metal-Enclosed
Switchgear Rated Up to 38 kV for Internal Arcing Faults
www.ieee.org
To Next Page
Loading...
Need help?
General