• SETTING
THE
PISTONS:
1.
Select a memory by pressing
Ml,
M2, M3, M4, M5 or M6. Note: Pistons cannot
be
set
if
the memory is locked. Please refer
to
the "Unlocking a Combination
Memory" section.
2.
Select the desired stops.
3.
Press and hold the SET piston, located under the Choir manual
to
the far left.
4.
While holding SET, press the desired combination piston. Then release both
pistons.
Note: Stops may
be
added or deletedfrom any combination using the above procedure.
•
LOCKING
A COMBINATION
MEMORY:
1.
Press and hold
Ml,
M2, M3, M4, M5
or
M6 for approximately five seconds.
"USING
INTERNAL
MEMORY"
or
"USING
CARD
MEMORY"
appears in the
Console Display first. Then
"MEMORY
(#) UNLOCKED" appears.
2.
While continuing
to
hold the memory piston, rotate the Alpha Dial either direction
until the Console Display reads
"MEMORY
(#) LOCKED."
3.
Release the memory piston. The memory is now locked.
5
To Next Page
Loading...
