• SETTING A TUTTI:
1.
Select the desired stops.
2.
Press and hold the SET piston, and press either TUTTI piston. The Tutti
is
set.
• LOCKING A TUTTI:
1.
Press and hold either TUTTI piston for approximately five seconds until "TUTTI
UNLOCKED" appears in the Console Display.
2.
While continuing
to
hold TUTTI, rotate the Alpha Dial either direction until the
Console Display reads "TUTTI LOCKED."
3. Release TUTTI. The Tutti is locked.
• RESTORING
THE
FACTORY TUTTI SETTINGS:
Note: Restoring either Tutti factory settingwill restore the other Tuttifactory setting.
These cannot be restored individually.
1.
Press and hold the TUTTI piston for approximately five seconds
..
The Console
Display reads
"TUTTI
LOCKED"
or
"TUTTI UNLOCKED".
2.
While holding TUTTI, press and hold SET for an additional five seconds. The
Console Display reads
"TUTTI
FACTORY DEFAULT".
3. Release both pistons.
MELODY COUPLERS
The Melody Couplers (11EL SW and MEL CH) are located
on
a piston under the Great
manual on the
right. The Melody Couplers light when they are engaged.
When
MEL
SW is lit, any selected stop
or
MIDI voice
in
the Swell division sounds from
the
highest key being played on the Great manual. This allows a solo melody and an
accompaniment to be played on the same manual.
When MEL CH is lit, any selected stop
or
MIDI voice in the Choir division sounds from
the highest key being played on the Great manual. This allows a solo melody and an
accompaniment to be played on the same manual.
In its default setting, the Melody Couplers affect keys
25
through
61
on the Great manual.
Its range is programmable and may be extended down to key
13
or
up to key 49.
Note: Melody Couplers can only be set in General combination pistons.
• SETTING THE RANGE
OF
THE
MELODY COUPLERS:
1.
Press and hold the SET piston, and press MEL SW
or
l\ffiL
CH
which begins
flashing.
2.
Release both pistons.
3.
While the Melody Coupler
is
flashing, press a key which corresponds to the lowest
note the range
is
to extend. Any note from key
13
to key 49 may be selected.
18