EasyManua.ls Logo

Rodgers 960 - MIDI Device ID and Connections

Rodgers 960
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
MIDI SEQUENCER UPDATE
MIDI Start, Stop and Continue messages generated by a sequencer are accepted
by
the
organ only when the MIDI Sequencer Update
is
enabled.
ENABLING
OR
DISABLING MIDI
SEQUENCER
UPDATE:
1.
Press and hold the SET piston, then turn the Select Knob clockwise (right) to
"MIDI SEQUENCER UPDATE".
2.
Release SET.
3.
Rotate the Alpha Dial to choose "ON" or "OFF". This selection
is
temporary. The
organ will always return to MIDI
"SEQUENCER
UPDATE ON" when the organ
is
turned on.
4.
Press General Cancel to exit.
Note:
The
organ uses the sequencer control messages to automatically record
the
stop
and
expression status at the beginning
of
a sequence.
MIDI DEVICE ID
MIDI Device ID allows the organist to select the MIDI Device identification number used
in
System Exclusive Stop Control messages. Normally, the organ both sends and recognizes
an ID number
of
17.
Stop Control messages with other ID numbers will be ignored.
This
ID
number can be changed to allow independent control over multiple organ consoles
connected via MIDI
or
to
facilitate storing multiple sets
of
registration information on a
sequencer recording. The number can be set to
1,
or
17
through 32. Setting the ID to 1
produces Stop Control messages which are compatible with older Rodgers PDI and
C-Series organs. The ID always returns to 17 when the organ
is
turned
off
.
SETTING
THE
MIDI
DEVICE ID:
1.
Press and hold the SET piston, then turn the Select Knob clockwise (right)
to
"MIDI
DEVICE
ID".
2.
Rotate the Alpha Dial to set the desired ID number.3.
Press General Cancel to exit.
SAVING A COMBINATION
MEMORY
The contents
of
any combination memory may be saved into a MIDI sequencer and later
reloaded into the organ.
1.
Connect the Sequencer MIDI IN to the organ Sequencer MIDI OUT. Connect the
Sequencer MIDI OUT to the organ Sequencer
MIDI
IN.
2.
Start the sequencer
in
Record mode.
3.
Wait until after any count-in measures, then hold the SET piston and momentarily
press the memory piston
(MI,
M2, M3, M4, M5
or
M6) for the memory to be
copied to the sequencer.
40

Table of Contents

Related product manuals