Rodgers 960 - MIDI Channel and Save Operations

2. Turn the Select Knob clockwise (rightfuntil the cursor moves to "NORM" on the
second MIDI menu screen.
3. Rotate the Alpha Dial to the desired setting ("UP 2", "UP 1", "NORM", "DN 1" or
"DN 2").
4. Press either the flashing
MIDI coupler piston or General Cancel to exit. Note: A
MIDI Save may
be performed to save this setting as the default. Please refer to
the "MIDI Save" section.
MIDI CHANNEL ASSIGNMENT
Using the Rodgers 960 as a MIDI keyboard controller for sequencing may require channel
assignment of the MIDI GT A coupler piston. All other MIDI coupler pistons transmit on
fixed channels. To reset the transmit channel of MIDI GT A, perform the following
procedure:
• ASSIGNING MIDI CHANNELS:
1. Hold the SET piston, then press MIDI GT A. The coupler piston flashes.
2. Turn the Select Knob clockwise (right) until the cursor moves to the channel
number.
3. Rotate the Alpha Dial to set the channel number.
4. Press either the flashing MIDI coupler piston or General Cancel to exit.
The channel number for MIDI GT A coupler piston can be saved in the settings on a
combination piston or saved permanently by performing the MIDI Save procedure. Note: A
MIDI Save may
be performed to save this setting as the default. Please refer to the "MIDI
Save" section.
MIDI SAVE
Changes made to MIDI settings are temporary and will be lost when the organ is turned
offunless those settings are saved. This is done by performing the following procedure:
• SAVING MIDI CONTROL SETTINGS:
1. While in any MIDI menu, make the desired changes.
2. To save, press and hold the SET piston, then press and hold General Cancel for
approximately five seconds.
3. Continue holding both pistons until the Console Display reads:
ALL MIDI MENU
SETTINGS SAVED
4. Release both pistons.
36
I,