Rodgers 960 - Factory Default Combination Settings; Restoring Factory Default Combination Settings

FACTORY DEFAULT
.
COMBINATION SETTINGS
The Rodgers 960 is shipped from the factory with default settings on combination memories 1
and
2. Registrations on Ml and M2 can be changed, but if original factory settings are desired, they
can be restored by the following procedure:
• RESTORING THE FACTORY DEFAULT COMBINATION SETTINGS:
1. Press and HOLD the memory select piston (Ml, M2, M3, M4, M5 or M6) for approximately
five seconds. The display will show "LOCKED" or "UNLOCKED."
2. While HOLDING the memory piston, press and HOLD the set piston an additional five
seconds. The display will read "MEMORY n FACTORY DEFAUL
1."
3. Release both pistons. (Note: Each memory must be individually restored by the following
procedure above.)
49