17
• UNLOCKING A TUTTI:
• VIEWING A
TUTTI
SETTING:
TREM
DEPTH
0
GT
MAl
N
RATE
0
1.
Press and hold either the TUTTI I
or
II piston.
2.
While holding one
of
the
TUTTI
pistons, press the SET piston. The stops
of
the
Tutti setting light.
3.
Press General Cancel to return to the Transposer menu.
Note: Tutti cannot
be
set unless
iris
unlocked.
1.
Press and hold one
of
the tutti pistons (I or II) for approximately five seconds until
"TUTTI LOCKED" appears in the Console Display.
2.
While continuing to hold TUTTI, rotate the Alpha Dial
either
direction until the
Console Display reads
"TUTTI
UNLOCKED."
3.
Release the TUTTI piston. The Tutti
is
unlocked.
3.
Turn the Select Knob until the cursor
is
on the tremulant name. Note: Please refer
to the "960 User Menu Items" section.
4.
Rotate the Alpha Dial until the Console Display reads the tremulant to be adjusted.
5.
Turn the Select Knob until the cursor
is
on the rate.
6.
Rotate the Alpha Dial until the Console Display reads the desired tremulant rate.
Note:
The
range
isfrom
-9
to
+9.
The
rate setting may be previewed by selecting
a corresponding stop
and
playing a note while the adjustment is made.
TUTTI
• ADJUSTING
THE
TREMULANT SETTINGS:
1.
Press and hold the SET piston.
2.
Turn the Select Knob counter clockwise (left) until the Console Display reads:
All
tremulants may be individually adjusted for rate and depth by performing the following
procedure:
There are times when a full organ registration
is
needed immediately. There are two tutti
pistons on the Rodgers 960, which can be set with any combination
of
stops. Press either the
TUTTI I or TUTTI II piston
or
toe piston
to
access a Tutti combination. These pistons are
reversible, so simply press again to cancel. When either Tutti is
in
use, the top four segments
of
the Crescendo/Tutti indicator lights red. The Crescendo/Tutti indicator
is
located
on
the
back coupler rail to the right
of
the tilt tabs above the Swell manual.
To Next Page
Loading...
