ORCHESTRAL VOICES
The Rodgers 960 also has a Orchestral Division which provides an additional six voices.
The Orchestral Division
is
located on the back coupler rail above the Swell manual to the right.
Il!jjl
iiiiiiiiiiiiiiOiiiRiiiCiiiHiiiEiiiS
TiiiRAiiiiiLiiiDiiiIViiiIiiiS
IiiiOiiiNiiiiiiiiiiiiiiiil1
Harpsichord
Orchestral Brass
FestivalTrumpet
Orchestral Strings
Handbells
Traverse Flute
When ORCHESTRAL TO PEDAL
is
engaged, the voice
is
coupled to the Pedal and also
plays on the Swell manual, unless ORCHESTRAL ON II and/or ORCHESTRAL ON I have
been selected. Then the voice will play on the Pedal and the selected manual(s).
The voices
of
this division play from the Swell manual unless transferred to another
manual. This
is
accomplished by using the tilt tabs located
to
the far right
of
this division
(ORCHESTRAL ON II and ORCHESTRAL ON I). A selected voice from this division can
be played individually
or
simultaneously on the Great and Choir manuals. When
ORCHESTRAL ON II and/or ORCHESTRAL ON I is engaged, the voice does not play on
the Swell manual. ORCHESTRAL ON II will transfer the voice to Great manual and
ORCHESTRAL ON I will transfer the voice to the Choir manual.
• SELECTING AND TRANSFERRING/COUPLING A VOICE:
1.
Press the desired voice's stop tab.
If
no other selection
is
made, this voice will play
on the Swell manual.
If
another manual(s) is desired, continue with the next step.
2.
Press the stop tab corresponding to the manual(s) on which the voice
is
to play
(ORCHESTRAL ON II and/or ORCHESTRAL ON I). The voice sounds from the
Great, Choir, or Great and Choir, but the voice does not play from the Swell
manual.
3.
When ORCHESTRAL TO PEDAL
is
selected, the voice will couple to the Pedal
and will simultaneously play from the selected manual(s).
31
To Next Page
Loading...
