Rodgers 960 - Digital Reverberation; Setting the Reverb Volume; Setting the Reverb Type; Setting the Reverb Time

4. Rotate the Alpha Dial to adjust the vol~me .
Note: An Audio Save may be performed to save this setting as the default. Please
refer to the "Audio Save "section.
DIGITAL REVERBERATION
The Rodgers 960 features an internal digital reverberation system. The volume, length
and type
of reverberated sound can be individually changed. Any changes made to the
reverberation settings from this menu are temporary and are lost when the organ
is turned ott:
unless they are saved by performing the Audio Save procedure. Note: An Audio Save may be
performed
to save this setting as the default. Please refer to the "Audio Save" section.
Note:
On some early 960 instruments the only adjustable setting is reverb volume. The reverb
time may
be adjusted however by an authorized Rodgers representative.
• SETTING THE REVERB VOLUME:
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) until the Console Display reads
"REVERB VOLUME". Release SET.
3. Rotate the Alpha Dial to set the desired reverb level (OFF, -31.25 through 6.25
dB).
Note: An Audio Save may be performed to save this setting as the default.
Please refer to the "Audio Save" section.
• SETTING THE REVERB TYPE:
1. Press and hold the SET piston.
2, Turn the Select Knob counter clockwise (left) until the Console Display reads
"REVERB TYPE". Release SET.
3. Rotate the Alpha Dial to set the desired reverb type ("ROOM 1", "ROOM 2",
"ROOM 3", "HALL I" or "HALL 2"). Note: An Audio Save may be performed to
save this setting as the default. Please refer to the "Audio Save" section
• SETTING THE REVERB TIME:
1. Press and hold the SET piston.
2. Turn the Select Knob counter clockwise (left) until the Console Display reads
"REVERB TIME". Release SET.
3. Rotate the Alpha Dial to set the desired reverb time ("SHORT", "NORMAL" or
"LONG"). Note: An Audio Save may be performed to save this setting as the
default. Please refer
to the "Audio Save" section.
CHOIR/GREAT TRANSFER
This control finds use in French organ literature. French organ design places the Great
division (Grand Orgue)
on the bottom manual and the Choir division (Positif) as the second
manual.
28