EasyManua.ls Logo

Rodgers 960 - Cross-Organ Usage and Maintenance

Rodgers 960
75 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
affecting the card memory. Note: Always lock
the
Personal Memory Card
when
inserting or
removing
from
the console slot. Failure to do so
may
result in loss
of
information.
USING A PERSONAL MEMORY CARD
ON
OTHER
RODGERS ORGANS
The same Personal Memory Card can be used
in
more than one Rodgers organ with the
Personal Memory Card feature. The information on the Personal Memory Card
is
kept
separate for each organ model.
If
a folder
is
created on a particular model, that folder will only
be accessible on that same model
of
Rodgers organ. A Personal Memory Card can hold sets
of
folders for several Rodgers organ models. When a Personal Memory Card
is
inserted into a
console slot, any folders created on that same model will be available.
Note: Folders created
on Rodgers Custom instruments are unique
and
only available
to
that instrument.
It
is
important to remember, although folders created on one model are "invisible" on
another model, these folders reduce the amount
of
free memory space on the card. A Personal
Memory Card which doesn't appear to have
as
much free space as
it
should, may
in
fact have
folders for other models stored on
it.
REINITIALIZING A PERSONAL MEMORY CARD
In some cases, it may be desirable to erase
all
information on a Personal Memory Card.
If
SET is held while inserting a Personal Memory Card
in
the console slot, a message
will
appear
in
the Console Display asking whether the Personal Memory Card should be reinitialized. To
perform the reinitialization, press SET.
If
it
is
decided not to initialize the Personal Memory
Card, press General Cancel again, then remove the card. A new Personal Memory Card must
also be initialized before it can be used.
Note: Initializing a memory card will erase all
previously stored information
on
the card!
REPLACING THE PERSONAL MEMORY CARD BATTERY
A 3-volt lithium battery (Rodgers part #1571-003
or
Radio Shack part #23-160)
is
required for replacement. Replacement batteries can be obtained from your local Rodgers
representative or at many camera stores.
To
replace the battery without losing the contents
of
the Personal Memory Card, open the battery compartment on the front edge
of
the card only
with the card inserted in the console slot while the organ is
on.
Otherwise,
all
information on
the card will
be
lost. The console continues
to
supply power to the Personal Memory Card
while the battery is being replaced. Be sure to observe the polarity marking when inserting the
new battery.
When a Personal Memory Card, whose backup battery has become weak, is inserted
in
the
console slot, a message appears
in
the Console Display warning the battery
is
low. The
message remains until General Cancel
is
pressed. Although the battery usually continues to
function for several days after the message first appears,
it
should be replaced at the earliest
opportunity.
WARNING: This is a
lithium
battery, which can present an e.xplosion risk. DO
NOT
expose the battery or the Personal Memory Card to fire. DO
NOT
attempt to
recharge this battery.
45

Table of Contents

Related product manuals