Roger Technology B70/1DCHP - Function Buttons and Display; Switching on or Commissioning; Display Function Modes; Parameter Display Mode

EN
61
8 Function buttons and display
PROG
UP
DOWN
TEST
BUTTON DESCRIPTION
UP
a
Next parameter
DOWN b
Previous parameter
+ Increase value of parameter by 1
- Decrease value of parameter by 1
PROG Travel acquisition
TEST Activate TEST mode
• Press the UP c and/or DOWN b buttons to view the parameter you intend to modify.
• 9WIXLIERHFYXXSRWXSQSHMJ]XLIZEPYISJXLITEVEQIXIV8LIZEPYIWXEVXWXSƽEWL
• Press and hold the + or - button to scroll quickly through values, to modify the parameter more quickly.
• To save the new value, wait a few seconds or move onto another parameter with the UP a or DOWN b button. The
HMWTPE]ƽEWLIWVETMHP]XSMRHMGEXIXLEXXLIRI[ZEPYILEWFIIRWEZIH
• 4EVEQIXIVWGERSRP]FIQSHMƼIH[LMPIXLIQSXSVMWRSXVYRRMRK4EVEQIXIVWGERFIZMI[IHEXER]XMQI
9 Switching on or commissioning
Power the control unit.
8LIƼVQ[EVIZIVWMSRSJXLIGSRXVSPYRMXMWHMWTPE]IHFVMIƽ]
Version installed P2.00.
Immediately afterwards, the displays enters the commands and safety device status mode. See chapter 10.
10 Display function modes
10.1 Parameter display mode
PARAMETER
PARAMETER
VALUE
See chapter 12 for detailed descriptions of the parameters.