Roger Technology B70/1DCHP - Page 75

EN
75
-HIRXMƼGEXMSRRYQFIV
8LIMHIRXMƼGEXMSRRYQFIVGSRWMWXWSJXLIZEPYIWSJXLITEVEQIXIVWJVSQQ to Q.
N.B.: The values shown in the table are indicative only.
Q 
HW version.
Example: 
Q 
Year of manufacture.
Q 
Week of manufacture.
Q 
Serial number.
Q 
Q 
Q 
FW version.
View manoeuvre counter
The number consists of the values of the parameters from R to R multiplied by 100.
N.B.: The values shown in the table are indicative only.
R 
Manoeuvres performed.
Example: x100 = 1.234.500 manoeuvres.
R 
R 
View manoeuvre hour counter
The number consists of the values of the parameters from K to K.
N.B.: The values shown in the table are indicative only.
K 
Manoeuvre hours.
Example:  = 123 hours.
K 
View control unit days on counter
The number consists of the values of the parameters from G to G.
N.B.: The values shown in the table are indicative only.
G 
Days with unit switched on.
Example:  = 123 days.
G 
Password
Setting a password prevents unauthorised persons from accessing the settings.
With password protection active (&3=TEVEQIXIVWQE]FIZMI[IHFYXXLIZEPYIW'%2238FIQSHMƼIH
Only a single password is used to control access to the gate automation system.
WARNING: Contact the Technical Support Service if you lose your password.
3  
3 
3 
3 
Password activation procedure:
• Enter the desired values for parameters 3, 3, 3 and 3.
• Use the UP
a
and/or DOWN
b buttons to view the parameter &3.
• Press and hold the
+ and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRWEZIH
• Switch the control unit off and on again. Check that password protection is activated (&3=).
Temporary unlock procedure:
• Enter the password.
• Check that &3= .
Password cancellation procedure:
• Enter the password (&3=).
• Save the values 3, 3, 3, 3 = 
• Use the UP
a
and/or DOWN
b buttons to view the parameter &3.
• Press and hold the + and - buttons for 4 seconds.
• 8LIHMWTPE]ƽEWLIWXSGSRƼVQXLEXXLITEWW[SVHLEWFIIRGERGIPPIHXLIZEPYIW3 ,3 ,3  and 3 
indicate that no password is set).
• Switch the control unit off and on again.
&3 
Changing password

Protection deactivated.

Protection activated.