Preparing for Use
R&S
®
RTO2000
18Getting Started 1332.9719.02 ─ 08
After connecting an additional monitor or projector to the instrument, configure it for
usage. The relevant settings are Windows settings but you can configure the displays
directly in the instrument setup.
1. Check the input type of the monitor or projector. Make sure to select the correct
cable. To use a VGA monitor, you need an active DVI-D to VGA adapter.
2. Press the [Setup] key.
3. Select the "System" tab.
4. Tap "Display / Monitors".
5. To show the instrument's display content only on the external monitor, select "Pro-
jector only".
To show the instrument's display content on both the oscilloscope and the external
monitor, select "Duplicate".
The touchscreen of the R&S RTO has a screen resolution of 1280 x 800 pixel. Most
external monitors have a higher screen resolution. If the screen resolution of the moni-
tor is set higher than the instrument's resolution, the application window uses a 1280 x
800 area of the monitor display. For full screen display, adjust the monitor's screen res-
olution using "Additional display settings".
Connecting External Devices
To Next Page
Loading...
