Rohde & Schwarz R&S RTO2000 Series - Performing a Mask Test

Trying Out the Instrument
R&S
®
RTO2000
65Getting Started 1332.9719.02 ─ 08
4.11 Performing a Mask Test
In the following example, you perform a mask test to determine whether the signal
exceeds a rectangular area.
The usage of masks tests is also shown in a short video that is available on the instru-
ment: "File" menu > "Tutorials" > "Mask Test".
1. To restore the default signal channel settings, press [Preset] and [Autoset].
2. Tap the "Masks" icon on the toolbar.
3. Tap the corner points of the first mask segment on the touchscreen. Select the cor-
ner points of one complete pulse, with a minor offset to the inside.
Tip: To create an exact rectangle, draw the diagonal of the rectangle on the
screen.
4. Tap "Finish segment" in the sidebar.
5. Add another mask segment above the positive pulse:
a) Tap "Add segment" in the sidebar.
b) Tap two points slightly above the pulse.
Performing a Mask Test