Rohde & Schwarz R&S RTO2000 Series - Keys and Controls; Power Key; Setup Controls

Instrument Tour
R&S
®
RTO2000
24Getting Started 1332.9719.02 ─ 08
The maximum input voltage is 40 V peak at 100 kΩ input impedance. The maximum
input frequency for a signal with the minimum input voltage swing of 500 mV (V
pp
) is
400 MHz. For detailed specifications, refer to the data sheet.
[RTO-B4]
Optional [Ref In] (left) and [Ref Out] (right) connectors coming with option R&S RTO-
B4 OCXO 10 MHz.
The input frequency ranges from 1 MHz to 20 MHz in 1 MHz steps. The input impe-
dance is 50 Ω.
The output frequency of the OCXO is 10 MHz, the impedance is 50 Ω. For detailed
specifications, refer to the data sheet.
[RTO-B6]
Optional connectors for the waveform generator (option R&S RTO-B6). For detailed
specifications, refer to the data sheet.
[Gen1, Gen2]
BNC connectors
[PattGen]
Connector for the pattern generator
RTO-B10
Optional GBIP connector coming with option R&S RTO-B10 GBIP interface. For
detailed specifications, refer to the data sheet.
3.3 Keys and Controls
3.3.1 Power Key
The [Power] key is located on the lower left corner of the front panel. It starts up and
shuts down the instrument's software.
The light of the key shows the instrument state:
●
Orange: standby, the main power switch is on, the software is shut down.
●
Green: The instrument is ready for operation.
3.3.2 Setup Controls
Setup keys set the instrument to a defined state, change basic settings, and provide
print and help functions. The intensity rotary knob adjusts the display contrast for sev-
eral display elements.
[Autoset]
The instrument analyzes the enabled channel signals, and adjusts appropriate horizon-
tal, vertical, and trigger settings to display stable waveforms.
Keys and Controls