Rohde & Schwarz R&S RTO2000 Series - Changing the Waveform Scaling and Position

Trying Out the Instrument
R&S
®
RTO2000
41Getting Started 1332.9719.02 ─ 08
2.
Tap "Close" in the signal icon for "Ch1Wfm2".
The signal icon is removed from the sidebar, the waveform is switched off.
3. Switch off the "Average:Ch1Wfm3" waveform using the toolbar function:
a) Tap the "Delete" icon on the toolbar.
b) Tap the waveform in the "Average: Ch1Wfm3" diagram.
The waveform is switched off, its signal icon and the empty diagram are removed.
4.4 Changing the Waveform Scaling and Position
As you can see on the y-axis of the display, the calibration signal has a vertical offset of
about 520 mV. The value can differ. This value is also indicated in the signal icon for
channel1 (2nd row).
If you press the [Ch1] key, the "Vertical" settings dialog box also displays the "Offset"
value. The offset is the DC component of the signal.
Changing the Waveform Scaling and Position