Trying Out the Instrument
R&S
®
RTO2000
42Getting Started 1332.9719.02 ─ 08
If you use a passive probe, you can filter the DC component by using the AC coupling
function. Then you quickly set the new trigger level, and try out the scaling functions.
1. In the [Vertical] area, press the [Ch1] key.
The "Vertical" dialog box is shown.
2. Change the "Coupling" to "AC".
3.
To close the dialog box, tap
.
The DC component of the signal is eliminated; the waveform position moves down
vertically and is now centered on 0 V.
Changing the Waveform Scaling and Position
To Next Page
Loading...
