Rohde & Schwarz R&S RTO2000 Series - Analysis Keys

Instrument Tour
R&S
®
RTO2000
30Getting Started 1332.9719.02 ─ 08
To set the number of acquisitions, press the [Trigger] key, select the "Ctrl/Action" tab,
and set "Average count (N-single count)".
3.3.6 Analysis Keys
The keys in the Analysis functional block provide direct access to measurement and
analyzing functions. If you press [Cursor], [Zoom] or [Meas], the action starts on first
keypress, and a second keypress opens the corresponding dialog box. If you press
another function key, the dialog box opens.
[Cursor]
Displays vertical and horizontal cursors in the active diagram and opens the "Cursor
Results" box.
Cursors are markers which are placed at points of interest on a waveform. The instru-
ment measures the cursor positions and delta values between parallel cursors.
If you press the key while a cursor measurement is enabled, the "Cursors" dialog box
opens.
In the "Cursors" dialog box, you can:
●
Configure up to 4 cursor sets
●
Define style and labels of the cursors
●
Connect the cursor to the waveform and couple the cursors
[Meas]
Starts the default automatic measurement for the active waveform and opens the
"Measurement" result box.
If you press the [Meas] key while a measurement is enabled, the "Measurements" dia-
log box is displayed, where you can:
●
Configure amplitude and time measurements, eye, spectrum, and histogram mea-
surements
●
Configure gated measurement
●
Configure long term and statistic measurements
●
Configure actions to be executed if specified limits are exceeded
App Cockpit
Opens the "App Cockpit" dialog box, where you can start an application or analysis
function directly, without knowing its position in the menu or toolbar.
The "App Cockpit" button
on the left end of the menu has the same effect.
Keys and Controls