Rohde & Schwarz R&S RTO2000 Series - Performing Mathematical Calculations

Trying Out the Instrument
R&S
®
RTO2000
62Getting Started 1332.9719.02 ─ 08
9. To remove the FFT results, tap the "Delete" icon and then the spectrum waveform.
10. Close the "Measurement" results.
4.9 Performing Mathematical Calculations
In addition to the measured waveforms, you can display calculated data to compare
the current measurement result with.
For example, you can display the absolute value of the waveform values as a math
waveform.
1. Press [Autoset].
2. Press the [Math] key.
3. In the "Setup" tab, select the "M1" vertical tab.
4. Select the "Basic" subtab.
5. Tap the "Source1" icon and select "Ch1Wfm1".
6. Tap the "Operator" icon and select "|x|".
7. Tap "Enable math waveform" to display the math waveform.
8. Close the "Math" dialog box.
The original and the math waveforms are displayed.
Performing Mathematical Calculations