Rohde & Schwarz R&S RTO2000 Series - Displaying Results

Operating the Instrument
R&S
®
RTO2000
90Getting Started 1332.9719.02 ─ 08
Update Ref Waveform
Copies the selected source waveform with all its settings to the reference waveform. If
the acquisition is running, the reference waveform is a snapshot. You can configure up
to four reference waveforms.
Select the required reference waveform (R1 to R4) in the sidebar.
Save Waveform
Exports the waveform data to file using the settings defined in [Save Recall] > "Wave-
forms / Results" > "Waveforms". The filename is created according to the autonaming
pattern.
Tap the icon and then tap the waveform to be exported. If you tap the display back-
ground, the selected waveform is exported, or a multichannel export is performed if
configured.
Spectrogram (option R&S RTO-K18)
Starts an FFT and the spectrogram. The FFT trace and the spectrogram are shown in
separate diagrams.
Tap the icon. Select the source in the sidebar, or tap diagram with the waveform to be
transformed. The diagrams are created from the selected waveform.
Zone trigger (option R&S RTO-K19)
Defines a zone trigger, which combines the trigger condition with the intersection or
non-intersection of one or more zones or masks.
Tap the icon and then tap the corner points of the zone on the screen.
5.6 Displaying Results
The results of automatic and cursor measurements, mask tests, and searches are dis-
played immediately in a result box.
There are several places to display the results:
●
In a floating result box in front of the diagrams, which you can move on the display
●
In a minimized view (result icon) on the sidebar
●
In a separate tab
●
For results of automatic measurements: in a docked tab below the diagram
The default position and the font size can be adjusted.
To arrange a result box on the display
► Touch the title of the result box and drag the box on the screen. The SmartGrid
indicates where the result box will be placed.
● If you drop the box on one of the buttons, the results are shown in a separate
tab besides, above, or below the diagram.
● If you drop the box on the sidebar, a result icon is created.
● If you drop the box somewhere else, a floating result box is created.
Re f 1
Displaying Results