Trying Out the Instrument
R&S
®
RTO2000
48Getting Started 1332.9719.02 ─ 08
4. Release the finger when the waveform segment of interest is visible in the zoom.
5. Tap "Keep" to convert the fingertip zoom into a standard zoom diagram.
4.6 Displaying the Waveform History
During a continuous acquisition, the instrument stores the acquired data in the memory
and shows the current acquisition on the display. The history accesses and displays
the samples that were saved before the current acquisition. When the acquisition was
stopped and a new acquisition is started with [Run Stop] or [Single], the memory is
cleared and written anew.
In the following example, you acquire 10 waveforms, and display the 3 most recent
waveforms.
1. In the [Horizontal] area, press the [Acquisition] key.
The "Horizontal" settings dialog box opens.
2. Set the "Average count" to 10 to perform 10 waveform acquisitions.
3. Close the "Horizontal" dialog box.
4. In the [Trigger] area, press the [Single] key.
10 waveform acquisitions are performed. The most recent acquisition is displayed
in the diagram.
5. In the [Analysis] area, press the [History] key.
The quick access "History" dialog box appears, and the history mode is on.
Displaying the Waveform History
To Next Page
Loading...
