Rohde & Schwarz R&S RTO2000 Series - Performing a Search

Trying Out the Instrument
R&S
®
RTO2000
63Getting Started 1332.9719.02 ─ 08
9. To remove the math waveform, tap the "Delete" icon and then the math waveform.
Alternatively, you can tap the signal icon of the math waveform to minimize the
waveform. Then close the signal icon.
4.10 Performing a Search
In the following search, you detect positive and negative overshoots, i.e. values that
exceed the high or low levels. To find these events, you can use the windows search.
To determine the search conditions, we use the results of the measurement example
described in Chapter 4.7.3, "Performing and Configuring the Quick Measurement",
on page 53.
1. Press the [Search] key on the front panel (Analysis area).
2. Select "C1" as "Source".
3. Select the search criteria: Enable "Window".
4. In the "Window" tab below, define the search conditions:
a) In the "Upper level" field, enter the result of the "High" level measurement.
b) In the "Lower level" field, enter the result of the "Low" level measurement.
c) As "Vertical condition", select "Exit" to find values that are outside the range
defined by the high and low levels.
Performing a Search