Rohde & Schwarz R&S RTO2000 Series - Toolbar

Operating the Instrument
R&S
®
RTO2000
83Getting Started 1332.9719.02 ─ 08
The diagram layout depends on the position where you drop the signal view, in relation
to an existing diagram.
Figure 5-5: SmartGrid positions
1 = In the existing diagram, overlay of signal
2 = New diagram on the left or right
3 = New diagram above or below
4 = New diagram on top of the existing diagram
5 = XY-diagram
6 = YX-diagram
To switch off a waveform
► Do one of the following:
● Select the waveform, and then press the [Signal Off] key.
● To switch off a minimized waveform, tap the "Close" icon in the upper right cor-
ner of the minimized signal view.
● Disable "Show channel" in the "Vertical" > "Channels" tab.
● Tap the "Delete" icon (Recycle bin) in the toolbar, and then the waveform.
If several waveforms overlap or lie close together, the upper (selected) wave-
form is switched off.
5.5 Toolbar
The toolbar provides direct access to important control and measurement functions. It
shows current date and time, and a message button. The selected function is highligh-
ted.
By default, the toolbar shows the most frequently used functions. You can configure the
content of the toolbar and hide the date/time display, see Chapter 5.5.2, "Configuring
the Toolbar", on page 84.
Toolbar