Operating the Instrument
R&S
®
RTO2000
82Getting Started 1332.9719.02 ─ 08
To minimize a waveform
► Choose on of the following ways:
● Tap the "Minimize" icon in the upper right corner of the waveform's signal label
in the sidebar.
● Drag the waveform from the diagram to the sidebar.
The waveform disappears from the diagram and the minimized signal view is
shown in the signal icon.
Tip: To set the waveform back to its previous diagram immediately, use "Undo".
To arrange a waveform using the SmartGrid
You can arrange waveforms in one of the existing diagrams, or in a new diagram.
The usage of the SmartGrid is also shown in a short video that is available on the
instrument: "Tutorials > Getting Started > SmartGrid".
1. Drag the signal icon to the diagram area, and move it around.
The Rohde & Schwarz SmartGrid appears and a blue area shows where the wave-
form will be placed.
2. Drop the waveform in the target area.
The waveform appears in an existing or in a new diagram, and it is selected for fur-
ther actions.
3. To change the size of the new diagram, drag its edge to the required position.
Working with Waveforms
To Next Page
Loading...
