Rohde & Schwarz R&S RTO2000 Series - Configuring the Toolbar; Using the Toolbar

Operating the Instrument
R&S
®
RTO2000
84Getting Started 1332.9719.02 ─ 08
5.5.1 Using the Toolbar
Using the toolbar is easy and straightforward.
Some of the toolbar functions are one-click actions. These actions are performed
immediately when you tap the icon.
Other toolbar functions are analyzing functions. These actions are interactive actions.
To use analyzing functions (interactive actions)
1. If several waveforms are shown in the diagram, select the waveform that you want
to analyze.
See: "To select a waveform" on page 81
2. Tap the icon of the function in the toolbar.
3. Check and adjust the settings in the sidebar on the right.
4. To define the analyzed area, do one of the following:
● Tap the required diagram.
● Drag a rectangle on the diagram.
The toolbar handling is also shown in a short video that is available on the instrument:
"Tutorials > Getting Started > Toolbar".
5.5.2 Configuring the Toolbar
You can configure the contents of the toolbar so that only the required functions are
displayed. Furthermore, date and time can be hidden. The toolbar configuration is part
of the user preferences. It is retained when you switch off and on the instrument, and
you can save it in the user preferences and user-defined preset.
Toolbar