Trying Out the Instrument
R&S
®
RTO2000
50Getting Started 1332.9719.02 ─ 08
4.7.1 Performing a Cursor Measurement
1. Restore the default signal channel settings: Press the [Preset] and [Autoset] keys.
2. Tap the "Cursor" icon on the toolbar.
3. Draw a rectangle on the screen where you want to place the cursor lines.
The cursor lines appear in the diagram and the "Cursor Results" box opens. The
measured waveform values at the cursor positions are displayed.
4. You can move the cursor lines in different ways:
● Touch a cursor line and drag it on the screen.
● Tap a cursor line to activate it. Then turn the [Navigation] knob to adjust the
position.
● Enter the position values in the result box.
5.
To save space in the display, tap "Minimize" in the result box.
The most important results are shown in the result icon.
Performing Basic Measurements
To Next Page
Loading...
