Rohde & Schwarz R&S RTO2000 Series - Page 91

Operating the Instrument
R&S
®
RTO2000
91Getting Started 1332.9719.02 ─ 08
1 = Floating result box
2 = Table in a tab on the left or right
3 = Table in a tab above or below
4 = New tab
To open the corresponding setup dialog box
1.
In the result box, tap the icon. Alternatively, double-tap the results.
2. If the sidebar opens, tap "Advanced Settings" in the sidebar.
The dialog box with corresponding settings opens.
To define the default position of results
1. Press the [Display] key on the front panel.
2. In the "Display" dialog box, select the "Diagram Layout" tab.
3. Under "Result box", select the "Default position":
● "Preview": result icon on the sidebar
● "Floating": floating result box in front of the diagrams
4. For result boxes of automatic measurements, the docked position is the default. In
docked position, the result table is placed below the diagram. To change the
default position of measurement results, select "Meas" menu > "Gate/Display" >
"Default" position.
To adjust the font size in result boxes
1. Press the [Setup] key.
2. Select the "Screen" tab.
3. Set the "Result dialog font size".
Displaying Results