Rohde & Schwarz R&S RTO2000 Series - Page 40

Trying Out the Instrument
R&S
®
RTO2000
40Getting Started 1332.9719.02 ─ 08
The three waveforms are now displayed in separate diagrams.
3. Rename the diagrams so that the label indicates the diagram content:
a) Double-tap the label for "Diagram 1: Ch1".
b) On the on-screen keyboard, enter Original.
c) Tap [OK].
d) Repeat these steps to rename "Diagram 2: Ch1Wfm2" to Envelope.
e) Rename "Diagram 3: Ch1Wfm3" to Average.
The diagram titles are shown together with the waveform number that is displayed
in the diagram.
4. To change the size of a diagram, drag its horizontal edge to the required position.
To delete waveform diagrams
For the procedures in the following sections, we need only the original waveform dia-
gram. So we close the other two diagrams.
1.
To minimize the waveform in diagram "Envelope: Ch1Wfm2", tap "Minimize" in
the "Ch1Wfm2" signal icon.
The diagram is removed and the signal icon on the sidebar displays a live view of
the signal.
Organizing the Display