Instrument Tour
R&S
®
RTO2000
25Getting Started 1332.9719.02 ─ 08
[Preset]
Resets the instrument to a default state. All measurements, mask tests, zoom, and
most individual settings are deleted, and all channels except for channel 1 are dis-
abled. You can define preset configurations and save them to a file. The [Preset] key
can be configured to set either factory defaults or a user-defined preset configuration.
[Save Recall]
Opens and closes the "File" dialog box, where you can:
●
Save instrument settings (user settings)
●
Load instrument settings which were saved before
●
Save waveform data and measurement results
●
Define a naming pattern for autonaming of files
[Setup]
Opens and closes the "Setup" dialog box, where you can:
●
Access Windows configuration and install firmware updates
●
Configure the touchscreen
●
Check and install option keys for software options
●
Check availability of hardware options
●
Configure remote settings, LAN settings, and GPIB
Camera
Performs the action that is assigned to the key in "File" menu > "Frontpanel Setup" >
"Hardkeys". By default, the key saves a screenshot of the waveform display.
[Help]
Opens the appropriate help topic for the active tab. If no dialog box is open, the con-
tents page of the help appears.
[Touch Lock]
Locks the touchscreen to prevent unintended use. When the touchscreen is off, the
key is illuminated. Press again to unlock the touchscreen.
[Display]
Opens and closes the "Display" dialog box to configure the appearance of the wave-
forms, the diagram layout, color tables, and the XY-diagram. You can also assign name
labels to the waveforms.
[Intensity]
Adjusts the intensity of the waveforms on the screen, or the background transparency
of dialog boxes, or the transparency of result boxes. If a dialog box is open, turning the
knob changes the transparency of dialog boxes. If a result box is open, the transpar-
ency of result boxes is changed. Otherwise the waveform intensity is adjusted. Press
the knob to toggle between the three settings. The controlled parameter and its value
are shown in the input box in the lower right corner of the screen.
Keys and Controls
To Next Page
Loading...
