Instrument Tour
R&S
®
RTO2000
22Getting Started 1332.9719.02 ─ 08
Figure 3-2: Rear panel of R&S
RTO
1 = AC power supply connector and main power switch
2 = LAN connector
3 = USB connectors, type A
4 = DisplayPort connector
5 = USB Device connector, type B
6 = DVI-D connector for external monitor
7 = Optional connectors for waveform and pattern generator (option R&S RTO-B6)
8 = External trigger output
9a = Optional connectors for digital probe (Mixed Signal Option R&S RTO-B1, shown in figure)
9b = Optional GPIB connector (option R&S RTO-B10, not shown in figure)
10 = External trigger input
11 = Optional OCXO with input and output of the reference signal (option R&S RTO-B4)
12 = Kensington lock slot to secure the instrument against theft
13 = Optional exchangeable hard disk: solid state disk (option R&S RTO-B18) or standard hard disk drive
(option R&S RTO-B19)
14 = Lugs to attach the accessory bag
AC power supply connector and main power switch
Connection to the AC power line. The R&S RTO can be used with different AC power
voltages and adapts itself automatically to it. The nominal voltage and frequency
ranges are displayed on the rear panel and quoted in the data sheet.
If grounding is not ensured by the mains system, ground the oscilloscope using the
protective earth conductor on the front panel and an appropriate cable.
The AC main power switch also interrupts the power supply of the OCXO (option
OCXO Reference Frequency, R&S RTO-B4).
When you power up the instrument, be sure to comply with the warm-up phase speci-
fied in the data sheet before you start measurements.
Rear Panel
To Next Page
Loading...
