Rohde & Schwarz R&S RTO2000 Series - Page 44

Trying Out the Instrument
R&S
®
RTO2000
44Getting Started 1332.9719.02 ─ 08
7. To return to the original scaling, try the [Undo] key in the [Navigation] area. Press
the [Undo] key repeatedly until the original scaling is displayed. Press the [Redo]
key to retrace the undone steps. Thus, you can toggle between the two displays
using the undo and redo keys until you perform a different action.
Alternatively, you can:
● Touch the screen with two spread fingers and pinch them together in horizontal
direction.
● Tap the "Undo" icon on the toolbar.
If you use an active single-ended probe, you can measure the DC component of the
signal directly at the probe tip with the integrated R&S ProbeMeter:
1. On the "Vertical" menu, tap "Probe Setup".
2. Make sure that the correct channel is selected on the left tab.
3. In the "Additional" section, tap "ProbeMeter".
A result box shows the DC voltage measured by the R&S ProbeMeter.
Changing the Waveform Scaling and Position