Rohde & Schwarz R&S RTO2000 Series - Page 58

Trying Out the Instrument
R&S
®
RTO2000
58Getting Started 1332.9719.02 ─ 08
Tip: You can also draw a rectangle on the screen to define the area on which the
histogram is to be based. The histogram range is indicated in the diagram.
3. To measure on the histogram, tap the "Measurement" icon on the toolbar.
4. Tap the histogram.
The waveform count for the histogram is displayed.
5. To display more measurement results for the histogram, press the [Meas] key on
the front panel.
6. In the "Measurements" dialog box, tap "Add/Remove Measurements".
7. Select the required histogram measurement types.
8. Tap "OK". Close the dialog box.
The histogram measurement results are displayed in the result box.
Performing Basic Measurements