Operating the Instrument
R&S
®
RTO2000
76Getting Started 1332.9719.02 ─ 08
Grid (2)
The grid shows the vertical and horizontal divisions. The division lines are labeled with
the correspondent values. The grid labels have the color of the waveform to which they
belong. If several waveforms are shown in one diagram, the grid has the color of the
selected waveform.
Sidebar (3)
The sidebar is the control center for all enabled waveforms. On the top, the horizontal
and trigger labels show the main timebase and trigger settings. If you tap a label, the
relevant dialog box opens with the tab used at last.
Figure 5-2: Horizontal and trigger label on top of the sidebar
1 = Resolution
2 = Record length
3 = Timebase (horizontal scale)
4 = Horizontal position
5 = Sample rate
6 = RT - real time, IT - interpolated time
7 = Trigger mode
8 = Trigger type, slope or polarity, source for A-event and B-event
9 = Trigger level
Below, each waveform is represented by a signal icon. If the waveform is shown in a
diagram, the signal icon displays its main vertical and acquisition settings. If you tap
the "Minimize" icon on the signal icon, the waveform switches from the diagram area to
the signal icon: the icon shows the real-time preview of the waveform. If you tap a sig-
nal icon, the dialog box with vertical settings for this waveform opens. See Chapter 5.4,
"Working with Waveforms", on page 80 for a detailed description.
In Figure 5-1, the signal icons Ch1Wfm1 and Ch2Wfm1 show the main settings, and
the waveforms are displayed in diagrams. All other waveforms are minimized and
shown in the signal icon.
Figure 5-3: Signal label on the sidebar
Touchscreen Display
To Next Page
Loading...
