Rohde & Schwarz R&S SMB100B - Connecting to Power; Connecting to LAN

Preparing for use
R&S
®
SMB100B
24Getting Started 1422.1045.02 ─ 06
b) Use a conductive floor mat and heel strap combination.
4.6 Connecting to power
For safety information, see "Connecting to power" on page 9.
1. Plug the AC power cable into the AC power connector on the rear panel. Only
use the AC power cable delivered with the R&S SMB100B.
2. Plug the AC power cable into a power outlet with ground contact.
The required ratings are listed next to the AC power connector and in the data
sheet.
4.7 Connecting to LAN
Network environment
Before connecting the product to a local area network (LAN), consider the follow-
ing:
●
Install the latest firmware to reduce security risks.
●
For internet or remote access, use secured connections if applicable.
●
Ensure that the network settings comply with the security policies of your com-
pany. Contact your local system administrator or IT department before con-
necting your product to your company LAN.
●
When connected to the LAN, the product may potentially be accessed from
the internet, which may be a security risk. For example, attackers might mis-
use or damage the product.
To connect to LAN
► Connect the LAN socket on the rear panel via an RJ-45 cable to the LAN.
Using DHCP (dynamic host configuration protocol), the R&S SMB100B
assigns the IP address automatically.
If connected to the LAN, the R&S SMB100B displays the IP address and the
hostname at the left bottom of the home screen.
Connecting to LAN