Instrument control
R&S
®
SMB100B
58Getting Started 1422.1045.02 ─ 06
For data input in dialog boxes, the instrument provides on-screen keypads for
entering numeric and alphanumeric values. Thus, you can always set the param-
eters via the touchscreen, the front panel, or an external keyboard.
To correct an entry
1. Using the arrow keys, move the cursor to the right of the entry you want to
delete.
2. Press the [Backspace] key.
3. Deletes the entry to the left of the cursor.
4. Enter your correction.
To complete the entry
► Press the [Enter] key or the rotary knob.
To abort the entry
► Press the [Esc] key.
The dialog box closes without changing the settings.
7.5.1 Entering numeric parameters
To enter values with the on-screen keypad
For numeric settings, the instrument displays the numeric keypad. The units
specified correspond to the units of the parameter.
1. Enter the numeric value.
Tip: For quick entry, you can enter a value in exponential representation, e.g.
1e7 for 10000000.
2. Tap the unit button to complete the entry.
The unit is added to the entry.
Tip: For quick unit change, you can enter shortcuts, e.g. for a frequency value
1e8h for 100 MHz.
For an overview of shortcuts supported by the R&S SMB100B, see chapter
"Unit Shortcuts" in the appendix of the user manual.
Entering data
To Next Page
Loading...
